flowmeter for corrosive liquid

After the initial debugging and normal operation for a period of time, the split electromagnetic flowmeter fails in the operation process, the common causes of failure are: the internal flow sensor connection layer, lightning strikes, environmental changes. Below, the staff of the flowmeter manufacturer will lead you to understand some common faults of the split electromagnetic flowmeter.

Sewage flowmeter is an induction meter used to measure the volume flow of conductive medium in pipes.

Split electromagnetic flowmeters are mainly used to measure the volume flow of conductive liquid and slurry in closed pipes. Including acid, alkali, salt and other highly corrosive liquids.

Electromagnetic flowmeter, with high precision, long life characteristics, in chemical industry, environmental protection, metallurgy and other fields and industries have been applied. However, in the process of use, due to the influence of many factors, it is easy to cause the inaccurate measurement results of the electromagnetic flowmeter.

Electromagnetic flowmeter is designed for the measurement of conductive liquid instrument, its high accuracy, wide range ratio, internal no moving parts, open flow parts, no pressure loss. Excellent corrosion resistance, high pressure resistance, strong adaptability, has been widely used in various production fields.

Electromagnetic flowmeter for our life has a great positive significance, for large pipe diameter occasions, the insertion electromagnetic flowmeter has obvious advantages, then about the insertion electromagnetic flowmeter you do not fully understand?

The installation of the electromagnetic flowmeter depends on the requirements of the customer’s working conditions, and then select the type, and install it according to the instructions or the guidance of the flowmeter manufacturer’s staff. The following points need to be noted when installing the electromagnetic flowmeter:

Electromagnetic flowmeter as a commonly used flow measurement instrument, the choice of its material is also an important factor. Because in the electromagnetic flowmeter, the part in contact with the medium is only the electrode and the inside of the measuring tube, it is necessary to select the correct electrode and lining material according to the characteristics of different media.

The correct selection of electromagnetic flowmeter is the prerequisite to ensure the good use of electromagnetic flowmeter. What kind of electromagnetic flowmeter should be selected should be determined according to the physical and chemical properties of the measured body medium, so that the diameter of the electromagnetic flowmeter, flow range, lining material, electrode material and output current, etc., can adapt to the nature and flow requirements of the measured body.

The transducer in the split electromagnetic flowmeter can form a body or separate type with the sensor, the integrated electromagnetic flowmeter is the integrated electromagnetic flowmeter, the split type becomes the split electromagnetic flowmeter, the flowmeter is a two-way measurement system, and the three integrators are installed: the forward total, the reverse total and the difference total